Not pairing to a device / How to pair BlueBEAT SE

Products > GOgroove Products > BlueBEAT SE
 
 
How to pair the BlueBEAT SE to a Bluetooth enabled device: Make sure BlueBEAT SE is in PAIRING MODE and that Power LED indicator lights are flashing. If not, please turn off the BlueBEAT SE and start from the beginning of Pairing your mobile Bluetooth device to the BlueBEAT SE instructions.

Try pairing the BlueBEAT SE to more than one Bluetooth enabled device.

Pairing instructions may differ depending on the device you are using. Please refer to your device’s user manual for further information.

  1. Make sure the BlueBEAT SE is off.

  2. Enter pairing mode by pressing and holding the multifunction button for 5 seconds. The LED indicator will flash red and blue and the headset will beep twice.

  3. On your audio device, find BlueBEAT SE in your Bluetooth menu. Select it for pairing. If required, use PIN: 0000.

  4. Auto-Connect can be performed with the last paired device. Turn on BlueBEAT SE by pressing and holding the multifunction button for 5 seconds. When powered on it will automatically reconnect with your audio device if Bluetooth is enabled.

  5. Disconnect by using your Bluetooth device menu. You can turn off BlueBEAT SE by pressing and holding the multifunction button for 5 seconds. It will beep 2 times and the LED indicator will blink 3 times before turning off. 

 

Please contact customer service if the troubleshooting above does not solve the problem.

 

 
 
Article ID: 676, , Modified: 6/20/2014 at 9:31 AM

Was this article helpful?

Share this article