This article will cover the steps needed to pair a BlueGATE TRM Bluetooth transmitter to a GOgroove Bluetooth headset. The same basic principles will still apply if you're not using a GOgoove headset, any other Bluetooth headset with A2DP Bluetooth will pair to the BlueGATE TRM.
Once you have the BlueGATE TRM paired with the Bluetooth headset, you can then set up the devices to use with a TV. This article will cover that process as well.
Step One - Pairing the transmitter to the headset:
For best results, make sure there are no other Bluetooth devices in the immediate area, or that their Bluetooth is turned off. It's possible the BlueGATE TRM or the device you're attempting to pair to the BlueGATE TRM may try pairing to something other than each other.
- Please make sure that both the headset and the transmitter are powered off.
- First, place the headset into pairing mode, for most devices, press and hold the power button or pairing button down for 7 seconds until the LED on the headset starts flashing red and blue. A flashing red and blue LED indicates the headset is in pairing mode.
- Second, place the transmitter into pairing mode, press and hold the power button button down for 7 seconds until the LED on the transmitter starts flashing red and blue. A flashing red and blue LED indicates the transmitter is in pairing mode.
- Place the headset and the transmitter close together, they will continue to flash red and blue for up to 15 seconds. Once they are connected, the LED's will stop flashing red and blue and will only blink blue every couple of seconds.
This photo demonstrates both the transmitter and headset in pairing mode. Please note the LED's on both devices are flashing red and blue.
Step Two - Connecting the BlueGATE TRM to the Audio Source:
Now that you have the transmitter paired to a Bluetooth headset, you can connect the transmitter to an Audio Source and enjoy the audio output through the paired Bluetooth headset.
The transmitter has an attached 3.5mm auxiliary cable and inside of it's box, comes with a red and white RCA adapter. You can connect the transmitter to your Audio Source via the headphone out jack (if it has one) or by using the red and white RCA adapter that came with the transmitter.
The photo on the left shows the RCA adapter (red and white) and the 3.5mm extension cable. The extension cable can be used to make the existing connection attached to the transmitter longer. The photo on the right shows where you will be plugging the transmitter into the Audio Source.
The audio source and can a TV, Cable Box, Satellite Box, DVD/Blueray, or Streaming Video Player. If your Audio Source has a headphone output jack, like shown above, you can plug the transmitter directing into that port. If your Audio Source does not have a headphone output jack, you will need to use the RCA adapter.
When plugging the transmitter into the Audio Source using the RCA adapter, make sure you are plugging the red and white jacks from the adapter into the red and white ports on your Audio Source. Make sure the ports you are plugging into are labeled AUDIO OUT, RCA OUT, ANALOG AUDIO OUT, or OUTPUT. You will not get any sound if you plug the transmitter into any port that is labeled AV1, AV2, or INPUT.
If you try plugging the transmitter into your TV first and you do not get any sound to the headset, please try plugging the transmitter into other ports labeled AUDIO OUT on the TV. If you still do not get any sound, please try plugging the transmitter directly into the source feeding the audio signal. This means plugging the transmitter directly into the Cable Box, Satellite Box, DVD/Blueray, or Streaming Video Player. Again, make sure you are plugging the transmitter into the red and white AUDIO OUT ports on these audio sources.
If the information within this article is not sufficient, please contact customer support.